Killswitch Question

linthat22

BANNED
I ordered a killswitch from allparts and I'm wondering how I install it.

It has two poles on the bottom. Is there a way I can hook a meter up to it to see which side is open?

I figured I'm gonna have it go to ground when I press the button and when I let go it'll be normal, but is it the hot line at that point?
 
No poliarity....just wire it inline with the positive wire to from the jack. When you press it, that breaks/kills the circuit.
 
I wouldnt think a killswitch would have polarity. Just a light switch, circuit broken, circuit complete.
 
I wouldnt think a killswitch would have polarity. Just a light switch, circuit broken, circuit complete.

Okay, break this out in tab for me. I've replaced pickups and switches before, but not a killswitch. You're gonna have to dumb down the dumb down version.
 
You have two wires going to your output jack on your guitar. One is the ground, the other is the hot. Somewhere on your hot wire, solder a wire to it. Solder another wire to ground. Your guitar should still work at this point. Touch the ends of the two wires you added. Now the guitar does not work, output is grounded out. It does not matter if the hot wire is in your left hand, and the ground wire is in your right hand, or the gound wire is in your left hand, and the hot wire is in your right. You are either compleating the circuit, or not. Solder one of the wires you added to one terminal of the switch, and the other wire to the other terminal. It does not matter which goes where.
 
You have two wires going to your output jack on your guitar. One is the ground, the other is the hot. Somewhere on your hot wire, solder a wire to it. Solder another wire to ground. Your guitar should still work at this point. Touch the ends of the two wires you added. Now the guitar does not work, output is grounded out. It does not matter if the hot wire is in your left hand, and the ground wire is in your right hand, or the gound wire is in your left hand, and the hot wire is in your right. You are either compleating the circuit, or not. Solder one of the wires you added to one terminal of the switch, and the other wire to the other terminal. It does not matter which goes where.

I can do that. Thank you!

And thank you all for the input!
 
killswitch-after2.jpg
like this but on the positive side of the circuit rather than the negative.
 
Step 1: make sure I have all my parts

LilyGuitar.jpg


For this I'm using an APC Persuader Lead Custom for the bridge pickup and a BKP Painkiller in the neck (with the pup flipped).

I have all new wire to ensure a clean install and grounding lugs to save me from burning up my pots (cause I'm a bad solderer).

I have 2 500k Bourns speed pots and a push/pull tone pot.

1 new 3 way switch and the wee killswitch in the corner.

The dog will be abused later.
 
Last edited:
Took the dremmel to the killswitch hole and I took a drill bit for the tone pot hole.

Shoulda dremmel'd it all. Low and slow and I wouldn't have given my guitar the relic look.
 
You have a wire going from the middle lug of your pickup selector that goes to your tone pot, then continues to your output jack, to the lug marked tip. Put your switch right before the output jack.


Do this with one wire.


PUP selector_______________________tonepot__________________killswitch_______________output jack
 
Back
Top